help

[hoveringsombrero]

here are the specs of the card, does any of this tell me the jumper settings?

why can't it be as simple as hd jumpers?

this is what the jumpers look like on the card, all in a row, the brackets are the ones that are closed by the jumpers, the others are open

J1 [--]
J2 [--]
J3 [--]
J4 --
J5 --
J6 --
J7 --
J8 --

Comments

[pennyspotless.livejournal.com]

i am a good girl.

This may help...

[artyste.livejournal.com]

http://www.creativehelp.com/kesscripts/creativehelp.asp?page=421 (http://www.creativehelp.com/kesscripts/creativehelp.asp?page=421)

It shows which jumper switches correspond with which IRQ settings..

Also..

[artyste.livejournal.com]

Apparently, the set of 8 jumpers you have listed are for the Input/Output range.. and there should be an additional set of 4 jumpers for the IRQ.. which is what the link I gave you is for, labled 9 - 12... however, the jumpers are backwards, so jumper 9 is for IRQ 12, etc.

I'm still searching for the list that shows which of the 1 - 8 jumpers need to be used for the I/O range you need.

Ok..

[artyste.livejournal.com]

As far as I can tell, here are the corresponding I/O jumper settings
Jumper1 = 280,
Jumper2 = 2A0,
Jumper3 = 2D0,
Jumper4 = [2E4],(which is the default)
Jumper5 = 340,
Jumper6 = 3A0,
Jumper7 = 3E0,
Jumper8 = Hex

so, maybe only jumper 4 needs to be closed and Jumper12 on the 4-set jumpers needs to be closed.
That's just a guess.. Kal might be able to help out more with these numbers.. or you guys have it all figured out by now.

Anyway.. hope it helped.

hey thanks :)

[eris.livejournal.com]

it's still mostly confusing to me but it looks like it's enough information for us to figure out

:)

Re: hey thanks :)

[artyste.livejournal.com]

I found it!!!!


http://www.viglen.co.uk/support/Manuals/VideoCapture/CreativeVideoBlaster/Videoblaster.asp

If that doesn't help.. nothing can.

Re: hey thanks :)

[artyste.livejournal.com]

heh.. you have to click on the Layout link of that page that I gave you...

Set your jumpers.. Jumper2 closed, Jumper3 closed, and jumper7 closed.

Re: hey thanks :)

[eris.livejournal.com]

i changed the jumpers to those settings and it's still giving me the same error

i rebooted
same
i reinstalled then rebooted
same

heh kal's probably going to bitch at me for fucking with it :)

Re: hey thanks :)

[artyste.livejournal.com]

I guess all you can do is go to that website with the jumper schematic and keep trying varius jumper settings for the I/O addresses until one works.. if none of them work.. then I'm at a complete loss..

[ex-oki86.livejournal.com]

Just read your post now.

I'll have to look into it later. too tired to think about it now.